Jims Catalogue

VALVE TRAIN TOOLS

NEW

ROCKER BOX COVER RATCHETING BOLT WRENCH

This reversible ratcheting box wrench is used on all Evolution Big twin and Sportster models to remove those hard to get at valve cover mount- ing bolts. This wrench is 9-3/4” long with a ergonomic rubber grip that keeps from scratch- ing the chrome or paint. Comes with a replace- able 1/4” drive 3/16” Allen bit. This tool has a low, thin, profile and allows clearance between the frame and engine. See below for replace- ment bits No. 770 - Use on all Evolution Big Twin Evolution Big twin 1984 to 1999 Use on all Evolution Sportster models 1984 to present. No. 771 - Replacement 3/16” Bits for JIMS tool No. 770 above. Sold in 3-packs.

MANLEY VALVE SPRING SEAT CUTTER This tool is for cutting the cylinder head lower valve spring seat area for high lift cams with .500” to .650” lift. Cuts 1.630” O.D. and .760” I.D. Includes a 3/8” diameter pilot. No. 1250 - Use on 74” and 80” Big Twins. MANLEY VALVE GUIDE SEAL CUTTER These tools are used for cutting valve guides while installed in the cylinder head to convert them to accept valve guide seals. No. 1251 - Cuts a .530” diameter. Supplied with a 3/8” diameter pilot. No. 1252 - Cuts a .562” diameter. Supplied with a 3/8” diameter pilot. No. 1253 - Cuts a .625” diameter. Supplied with a 3/8” diameter pilot.

8

VALVE GUIDE PUSHER SET

This kit lets you push the valve guide into H-D ® and aftermarket heads rather than drive it in with a hammer. No. 1058 - Use on 5/16” I.D. guides. No. 1054 - Use on 3/8” I.D. guides.

CUTTER PILOT No. 1254 - 5/16” diameter pilot for any of the spring seat or valve guide seal cutters shown above.

Endorsed By

VALVE SEAT LAPPER TOOL Use this tool to perform the final profile lapping of the valve seat. The suction cups affix to either dished or flat, and small or large valve faces. The handle is comfortably shaped, and ideal for quick and smooth rotations. No. 1774 - Use on all cylinder head valve types.

HEAD BOLT TORQUE GAUGE This accurate gauge allows the measuring of 90˚ when tightening Twin Cam ® or Evo head bolts. Torque sequence lasered on gauge, with instructions. No. 2392 - Use on all Twin Cam ® , EVO, and Sportster ® models 1984-present.

148