Jims Catalogue

CAM BEARINGS

INNER CAM BEARINGS LATE TWIN CAM ®

INNER CAM BEARINGS EARLY TWIN CAM ®

These American made bearings are a must for any cam change or service. To remove bearings from case use JIMS ® No.993 Cam Bearing Remover Tool. To install bearings use JIMS ® Tool No.991. Doing service in this area will require other JIMS ® Tools as listed: 2 - No.33443-84 - Pump Alignment Screws; No.1285- Cam/Crank Sprocket Lock; No.994 and No.990- Cam Assembly Tools. Sold in a pack of 2. No. 8991K - Use on 2006 - Present FXD. Use on 2007 - Present FXST and FL.

These American made bearings are a must for any cam change or service. To remove bearings from case use JIMS ® No.1279 Cam Bearing Remover Tool. To install bearings use JIMS ® Tool No.1278. Doing service in this area will require other JIMS ® tools as listed: No.1277 - Cam Shaft Remover and Installer; No.1285 - Cam / Crank Sprocket Lock; No.1283 - Cam Chain Tensioner Tool, and No.1280 - Outer Cam Bearing Puller (optional). Sold in a pack of 2. No. 9198K - Use on 1999 - 2006 FLH. Use on 2000 - 2006 FXST. Use on 1999 - 2005 FXD.

12

MID TWIN CAM OUTER CAM BEARING KIT

EARLY TWIN CAM ® OUTER CAM BEARINGS

These are quality bearings that meet or exceed factory OEM specifications H-D ® No.8983 and 8990A. Use JIMS ® tool No.1280 to pull bearing from front cam. To pull rear-bearing use JIMS ® No.963 your bearing race puller wedge attachment. To install and remove camshafts use JIMS ® No. 1277. No. 8150 - Use on mid 2000 - 2006 FLH & FXST. Use on mid 2000 - 2005 FXD.

These are quality bearings that meet or exceed factory OEM specifications. Replaces H-D ® No.8890. Sold in pairs . No. 8990K - Use on Twin Cam 88 ® 1999 - mid 2000.

INNER CAM BEARING BIG TWIN This is the original and only cam bearing to use in your Big Twin. American made by Torrington ® . Don’t trust any other Cam Bearing. For the best results, install bearing with JIMS ® Cam Bearing Installation Tool No.2188. To remove Cam Bearing use JIMS ® No.95760-TB Cam Bearing Puller. To remove cam cover use JIMS ® Tool No.2243. No. 9058 - Use on Big Twin 1958-99 single cam only. ( NOTE: Includes aftermarket engines.)

INNER CAM BEARING SPORTSTER ® American made by Torrington ® . For the best results install bearing with JIMS ® Cam Bearing Installation JIMS ® Tool No.97273-60. To remove bearing use JIMS ® Tool 95760-XL. No. 9057 - Use on Sportster ® 1957-1990, Use on Buell ® 1987-1990. ( NOTE: Includes aftermarket engines.)

71