Jims Catalogue
SWINGARM & REAR FORK TOOLS
PIVOT BEARING REMOVER / INSTALLER TOOL Use this tool when removing and installing the swingarm pivot bearing for 1984-present Softails ® that use H-D ® No.9076, or 9270A. This tool can also be used to remove and install front fender spherical bearings on Heritage Softail ® Springers 1997-02 & 2004-present that use H-D ® No.9149. For more details see No.2250-IS instructions. No. 2250 - Use on all 1984-present FXST’s for pivot bearing. Use on 1997-02 & 2004-present FLSTS for spherical bearing.
1
4
7
2
3
PARTS AVAILABLE SEPARATELY
NO.
QTY.
DESCRIPTION INSTALLER CUP
PART NO.
1 2 3 4 5
1 1 1 1 1
35316-80-1
END CAP SCREW WASHER
2250-1
1237 2038
INSTRUCTION SHEET
2250-IS
1
3
2
5
8
6
4
2
CLEVEBLOC BUSHING ASSEMBLY REMOVER / INSTALLER TOOL
Use to remove and replace swing arm cleveblocs. Cleveblocs, part No.47556-81, are silicone filled bushings that will be damaged if not installed prop- erly. JIMS ® tool presses on the outer sleeve of the bushing, preventing damage to the clevebloc. Can be used with or without a press. For more details see No.1743-IS instructions. No. 1743 - Use on all FLT, FLH 1980-2001. Use on all FXR 1982-94, 1999 and all aftermarket FXR style frames.
1
2 CLEVEBLOC SPREADING TOOL
21
Use to install the swing arm in a 5-Speed rubber mount frame. When cleveblocs are replaced they need to be positioned to install in the rear of the transmission. This tool will spread the swing arm cleveblocs allowing for installation of the swing arm. For more details see No.1707-IS instructions. No. 1707 - Use on all Big Twin 1980-2001 FL. Use on all FXR 1982-99.
PARTS AVAILABLE SEPARATELY
NO.
QTY.
DESCRIPTION PRESS PLUG
PART NO.
1 2 3 4 5 6 7 8 9
1 1 1 1 1 1 1 1 1
1743-1 1743-2 1743-3
PRESS CUP INNER PRESS CUP OUTER
BEARING
2010 2136 1246 2137 2038
PARTS AVAILABLE SEPARATELY
NUT
NO.
QTY.
DESCRIPTION FLANGED NUT
PART NO.
LONG BOLT SHORT BOLT
1707-2 1707-1 1707-IS
1 2 3
2 1 1
SHAFT
WASHER
INSTRUCTION SHEET
INSTRUCTION SHEET
1743-IS
208
Made with FlippingBook Online newsletter