Jims Catalogue

FRONT FORK & NECK TOOLS

5

2

3

2

NEW

5

3

4

1

If applying heat use to race use No. 899 heat stickers. See Page 212.

FRONT FORK COMPRESSOR TOOL

6

Use to compress the fork springs in cartridge style shocks when serv- icing or rebuild- ing. The com- pressor can be mounted in a vise

PARTS AVAILABLE SEPARATELY NO. QTY. DESCRIPTION PART NO. 1 1 MAIN BODY 1776-11 2 1 SLIDE, MAIN BODY 1776-10 3 1 FL ADAPTER 1776-3 4 1 DAMPER ROD EXTENTIONS 1776-9 5 1 SPECIAL ALLEN SCREW 1776-6 6 1 INSTRUCTION SHEET 1776-IS

4

for easy hands free servicing. Also includes an adapter for FL forks to eliminate direct contact with spring coil and a special rod to pull up the fork damper rod. For more details see No.1776-IS instruc- tions. No. 1776 - Use on all cartridge-style shocks fork assemblies.

1

FORK STEM BEARING REMOVER Use this tool to remove the lower fork stem (Triple Clamp) tapered bearing. For more details see No.1414-IS instructions. No. 1414 - Use on all lower fork stems that use a

H-D ® No.48300-60 style bearing. Order JIMS ® Hard End Cap, No.1048 below when using on early XL 1978-81.

EXTENDED FORK COMPRESSOR ADAPTER TOOL This tool must be used with JIMS Front Fork Compressor tool No.1776 above. This adapter tool No.1777 will allow you to work on forks 2-inch undersize to approximate- ly 16” oversized forks, depending on the original length of the fork assembly. Will not work on inverted model forks. For more details and parts list see No.1777-IS instructions. No. 1777 - Use on overstock length cartridge-style shocks fork assemblies.

PARTS AVAILABLE SEPARATELY

NO. QTY.

DESCRIPTION

PART NO.

1 1 2 2 3 1 4 2 5 2 6 1 7 1

BEARING REMOVER

1414-1

SCREW

1024 2013 1717 2031 1025

PULLER BAR

3/8” - 16 X 11” BOLTS 3/8” SAE WASHER HARDENED TIP INSTRUCTION SHEET

1414-IS

21

HARD CAP This hard cap will protect the 3/4" fork stem when using the above tool No. 1414 on Sport- sters. Also works on 1955 to 2006 Big Twin

FORK TUBE SPRING RETAINER REMOVER/ INSTALLER TOOL

sprocket shafts, when pressing flywheels out of engine cases. See page 184. For more details see No.1048-IS instruction sheet.

This tool has two pins that will locate inside the top of the fork tube on the spring retainer screw. You will then be able to remove or install this retainer to service the fork assembly on early drum brake fork model Sportsters and Superglides. No. 1170 - Use on 1952 - 1972 Sportsters, and 1970 - 1972 Superglide .

No. 1048 - Use on

1978-1981 Sportsters

206