Jims Catalogue

SPROCKET SHAFT BEARING TOOLS

2

8

7

If applying heat use to race use No. 963 heat stickers See Page 212 for details.

5

3

6 4

1

BEARING AND RACE PULLER TOOL This tool has been designed to remove the flywheel sprocket shaft inner bearing race with the supplied JIMS ® T-bar and hardware. If heat is needed to remove race see tool No. 899 on page 212. For more details see No.963-IS instructions. No. 963 - Use on all Twin Cams ® 2003-present.

15

2

1

Use to remove Timken ® bearing (H-D ® No.9028) or No.9029 on Big Twins, 1955 Panhead to present Twin Cam ® , including JIMS ® 120”, 131”, or 135” engines. Use to remove the flywheel sprocket shaft inner bearing race or the Timken ® bearing. Also removes pinion shaft inner bearing race on Sportster ® 1954-present, including all Buell ® ’s to present. Use to correctly remove press fit trans- mission gears and bearings from input and output shafts on all V-Rod ® models 2002-present.

TIMKEN ® BEARING OR RACE INSTALLER ADAPTER KIT This tool will upgrade your earlier JIMS ® No.97225-55 bearing installer tool to work on the latest fine spline Twin Cam ® sprocket shafts. This tool is designed to install either H-D ® No.9028 Timken ® bearing or the roller bearing race included with H-D ® No.24004-03. Bearing assembly onto the sprocket shaft as shown in the above photos. For more details see No.973-IS instructions. No. 973 - Use on all Big Twins 2006-present FXD's or 2007-present FXST's & FL's. Also use on

PARTS AVAILABLE SEPARATELY

JIMS ® 120”, 131”, or 135” motors. PARTS AVAILABLE SEPARATELY

NO.

QTY.

DESCRIPTION WEDGE PLATE

PART NO.

1 2 3 4 5 6 7 8 9

2 1 3 2 1 1 2 2 1

963-1 1024 2013 963-2 995-3 2030 2031 963-IS 1048-1

SCREW

PULLER BAR

NO.

QTY.

DESCRIPTION

PART NO.

WEDGE PLATE HARDWARE KIT

1 2 3

1 ADAPTER 1 SLIDER

973-1 973-2 973-IS

HARDENED CAP, EARLY HARDENED TIP, LATE

1 INSTRUCTION SHEET

SCREW WASHER

INSTRUCTION SHEET

179