Jims Catalogue

ROD TOOLS

ROD HOLDER TOOL

WRIST PIN BUSHING REAMER TOOL

(Note use with rods in or out of motor) Use this kit to ream your wrist pin bush- ings to H-D ® specifi- cations. These ream- ers are made to exact tolerances, piloted to locate from the I.D. of your newly replaced

Use to keep con- necting rods in place and eliminate twist- ing or bending of the connecting rod while reaming or honing the wrist pin bushings. Works well with JIMS ® No.1051, 95970- 32C wrist pin bush-

JIMS ® wrist pin bushings. Reams are easy to use with their designed lead in taper at the start of each ream. Use JIMS ® No.1284 Rod Clamp tool. For more details see No.1726-IS instructions. No. 1726-3 - Use on Twin Cam ® 1999-2005 FXD, 1999-2006 FL, & 2000-2006 FXST. No. 1726-1 - Use on all Big Twins that use the late diameter size wrist pins 1973 to present ( NOTE: Includes aftermarket motors.) No. 1726-2 - Use on all Sportsters ® 1957-present and Buell ® 1987-present, except 1125R. NOTE: Some wrist pin bushings will need a small amount of ball honing to give specified fit, see H-D ® service manual for specifications.

ing tools, and JIMS ® No.1726-1, 1726-2 and 1726-3 wrist pin bushing reamers. For more details see No.1284-IS instructions. No. 1284 - Use on all Twins and Buell ® Blast. Includes Twin Cam ® ‘A’ and ‘B’.

10

PARTS AVAILABLE SEPARATELY

NO. QTY.

DESCRIPTION CLAMP BASE

PART NO.

1 1 2 2 3 2 4 2 5 1

1284-1 1284-2 1284-3

HOLD DOWN NUT, T/C HOLD DOWN NUT, EVO

THUMB SCREW

1286

INSTRUCTION SHEET

1284-IS

Endorsed By

CONNECTING ROD BUSHING TOOL Use to remove and replace wrist pin bushings with- out removing connecting rods from crankcases. Use JIMS ® No.1284 Rod Holder tool. For more details see No.95970-IS or No.1051-IS instructions. No. 1051 - Use on all 1999-2006 FL, 1999-2005 FXD, & 2000-2006 FXST. No. 95970-32C - Use on all single cam Big Twins, XL’s, Buell’s, and 45’s. PARTS AVAILABLE SEPARATELY NO. QTY. DESCRIPTION PART NO. 1 1 BOLT 2009 2 2 BRASS WASHER 2129 3 1 SLIDER 1051-1 OR 95970-32C-1 4 1 PULLER 1051-2 OR 95970-32C-2 5 1 BEARING 2010 6 1 COUPLING NUT 2011 7 1 INSTRUCTION SHEET 1051-IS & 95970-IS

ROD ALIGNMENT TOOL Use to check rod straightness without removing rods from case. The alignment tool is 4-1/2” long. For more details see No.1010-IS instructions. No. 1158 - Use on JIMS ® Twin Cam ® Rods (.827” Wrist Pin) No. 1148 - Use on all Twin Cam ® ‘A’ and ‘B’. ( NOTE: Includes aftermarket motors.) (.927” Wrist Pin) No. 1010 - Use on all Big Twin single cam (.791” Wrist Pin)

161