Jims Catalogue

CAM COVER TOOLS

Endorsed By

Endorsed By

9

CAM BUSHING INSTALLER DRILL JIGS

Just press in new JIMS ® cam bushing with jig and drill through guide hole in jig, through both bushing and cam cover. Press in new staking pin No.2201, and bushing is locked in place. Jig comes complete with instructions. Use to install and drill dowel pin hole in cam bushing to the factory specification. Supplied with drill. FOR JIMS ® BUSHING NO.25581-36 & NO.25597-36 No .1011-36TB - Use on all Big Twin 1936-69. For more details see No.1011-IS instructions. FOR JIMS BUSHING NO.25581-70 No .1012-70TB - Use on all Big Twin 1970-present single cam only. ( NOTE: Includes aftermarket motors.) For more details see No.1012-IS instructions. FOR JIMS BUSHING NO.25586-37 No .1017-37TB - Use on all Sportster ® 1954-present. Use on

BIG TWIN CAM ® SEAL INSTALLER AND REMOVER • REMOVES CAMSEAL • INSTALLS CAMSEAL • REMOVES CAMCOVER

Use to install and remove a 1970-1999 cam seal without removing the cam cover. This tool is very simple to use. Just mount tool in cover, screw in the two removing screws, turn center, and out comes the cam seal. The new seal is pressed in with the same tool, square and flat for a no leak fit. This tool will also remove cam cover from case. For more details see No.2243-IS instructions. No. 2243 - Use on all Big Twin 1970-1999 single cam only.

Buell ® 1987-2006. Use on Big Twin 1937-48 Sidevalves. For more details see No.1017-IS instructions.

NOTE: When replacing seal, we recommend JIMS seal No.2169. See page 126

PARTS AVAILABLE SEPARATELY

NO. QTY.

DESCRIPTION

PART NO.

1 1 2 2 3 2 4 1 5 1 6 1 7 1 8 1

CLIP

2304 2297 2287

NO.31 SIZE DRILL - JOBBER H.S.S. Use with all JIMS ® drill jigs that use JIMS ® No.2201K staking pin. These drills are ultra sharp for the safest possible drilling. No. 1097 - Use on all models.

MACHINE SCREWS

SCREW

CUP, INSTALLER & REMOVER, CAM SEAL SCREW, INSTALLER & REMOVER, CAM SEAL CAP - USED WHEN REMOVING CAM COVER PLATE, INSTALLER & REMOVER, CAM SEAL

2243-4 2243-3 2243-2 2243-1 2243-IS

INSTRUCTION SHEET

157