Jims Catalogue

CAM BEARING INSTALLER TOOLS

TWIN CAM INNER CAM BEARING INSTALLER

INNER CAM BEARING INSTALLATION TOOL This tool easily presses the inner cam bearing smoothly into the right case, with the cases assembled, to

NEW

2

3

5

4

1

5

the proper depth. Use a new JIMS perform- ance bearing No.9058 and to remove old use tool No. 95760-TB. For more details see No.2188- IS instructions. No. 2188 - Use on all Big Twin 1958-present single cam only. ( NOTE: Includes aftermarket motors.)

6

1

9

3

2

4

PARTS AVAILABLE SEPARATELY

Use this tool to press in, and install, the two inner cam bearings JIMS ® No.8991K. This tool has been designed to press from the letter side of the inner cam bearings, by putting all the pushing pressure to the very outer wall of bearing shell. Eliminats any damage to the bearings, cam and cases. This tool will stop at the case and set the bearing depth to .023” to .028” below the case surface. Use with JIMS ® Tool No.1279 to remove bearings. For more details see No.787-IS instructions. No. 787 - Use on all T/C, 1999-present.

NO. QTY.

DESCRIPTION

PART NO.

1 1 2 1 3 1 4 1 5 1 6 1

SCREW

1024

TOOL, CAM BEARING

97272-60

O-RING

2310

PLATE

2188-1

TOOL, DRIVER, CAM BEARING

2190

INSTRUCTION SHEET

2188-IS

CAM BEARING TOOL Use to install inner cam bearing, with Handle No. 33416- 80 on right (Handle slips through the

PARTS AVAILABLE SEPARATELY

NO. QTY.

DESCRIPTION

PART NO.

1 1 2 1 3 1 4 1 5 4 6 1 7 1

PLATE INSTALLER

1278-1 1278-3

INNER CAM BEARING INSTALLER

outer cam bushing for alignment). All of JIMS ® bearing installers are designed with an angle to apply all the pushing force to the extreme outer diameter of the bearing. For more details see No.97272-IS instruc- tions. No. 97272-60 - Use on all Big Twin 1958-present single cam only. ( Note: Includes aftermarket motors. ) No. 97273-60 - Use on all Sportster ® 1957-90. Use on Buell ® 1987-90. For more details see No.97273-IS instructions.

SCREW

1024 2190 1213 2310

SPUD CAM BEARING TOOL

KNURLED SCREWS

O-RING

INSTRUCTION SHEET

787-IS

1

RACE & BEARING INSTALL TOOL HANDLE Use with No.s 33071-73, 34810-84, 94547-80A & B, 97272-60, and 97273-60. Approximately 12” long. For more details see No.33416-80-IS instructions. No. 33416-80

PARTS AVAILABLE SEPARATELY

NO. QTY. DESCRIPTION

PART NO.

1 1 O-RING

2310

152